Home > Error Codes > Philips Respironics Error Codes

Philips Respironics Error Codes


And it is 8 pages.So I start searching the web to find the manuals or instructions on how to do this.It didn’t take to long before I found an actual Respironics Otherwise, replace card. Warranty Did you know your CPAP and/or BiPAP machine comes with a manufacturer warranty. If the issue is still not corrected, we will replace any damaged electronics as necessary (depending on availability) to ensure the devices are operating within manufacturers specifications. have a peek here

I can have it fixed/replaced when I get home, but I would like to get it running for the next few days. DONATE to Apnea Board Change your own pressure - Get the Clinician Setup Manual for your CPAP here 02-25-2012 07:20 PM Donate to Apnea Board SuperSleeper Posts: 9,966 Joined: Feb 2012 It was an old REMstar Pro with an E-24 error, usually associated with some sort of water damage (figure 1). In the troubleshooting guide section, the cause for "Er XX" is "The device has detected an operating fault" and the recommended action is "Contact the technical support". http://www.apneaboard.com/wiki/index.php?title=REMstar_error_codes

Remstar Pro Error Codes

C-201 SMARTCARD_BAD_CDB_VERSION Card contains a storage format that is not supported. These photos should also prevent you from feeling any temptation to open your CPAP machine out of curiosity. Generated Mon, 05 Dec 2016 22:49:33 GMT by s_ac16 (squid/3.5.20) C-100 SMARTCARD_BAD_CPB_CHECKSUM Card is corrupt and should be reprogrammed.

Refer to the "see also" section of this page for more information regarding the tones. This page has been accessed 3,339 times. Remove card and reinsert properly. Philips Respironics System One Error Codes To access them, you will need to join the Apnea Board Forum, log in, and then go to our Private Files and Links area, below the forums.

Paula's (pre-2007) REMstar Error Code page is here: http://www.apneaboard.com/wiki/index.php?title=REMstar_error_codes The new Philips-Respironics REMstar & BiPAP Error Code page for (50 and 60-series System One machines) is here: http://www.apneaboard.com/wiki/index.php...rror_codes SuperSleeper Apnea Board Respironics Cpap Machine Error Codes Attached File(s) Thumbnail(s) SuperSleeper Apnea Board Administrator www.ApneaBoard.com INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED AS MEDICAL ADVICE. Please note: these codes are for older pre-2007 REMstar machines. click resources Directly under the display are <> buttons (the so called “user buttons”).

Thread: Author Replies: Views: Last Post [Equipment]Respironics blower failure SleepyinMTL 2 106 12-03-2016 12:52 AM Last Post: trish6hundred REMStar SE with DOT Compliance musicman85 11 366 12-01-2016 09:08 PM Remstar Pro Error 25 And in the lower right is the START/STOP button. The Cost of Repair Versus Replacement Be sure to weigh your options as to the cost of the repair versus the purchase of a new CPAP machine. Note: this article includes some technical information copied from the REMstar Pro Service Manual.

Respironics Cpap Machine Error Codes

So I take it that the machine got soaked with water, correct? check that C-10 SMARTCARD_BAD_RI_BRAND Card is corrupt and should be reprogrammed. Remstar Pro Error Codes Not just one at a time but the complete list.Thank you Yeah.....they're in the "Service Manual" for the machines. Respironics Cpap Service Required ALWAYS SEEK THE ADVICE OF A PHYSICIAN BEFORE SEEKING TREATMENT FOR MEDICAL CONDITIONS, INCLUDING SLEEP APNEA.

Perhaps card is intended for another device. navigate here C-101 SMARTCARD_BAD_CPB_VERSION Card is corrupt and should be reprogrammed. C-400 SMARTCARD_BAD_DDCB_VERSION Card is corrupt and should be reprogrammed. C-503 SMARTCARD_FILE_READ_FAIL Card is corrupt and should be reprogrammed. Remstar Shuttle Error Codes

We are flexible like that. C-300 SMARTCARD_BAD_UIDB_VERSION Card is corrupt and should be reprogrammed. C-7 SMARTCARD_NOT_PRESENT C-8 SMARTCARD_12C_READ_FAIL Card inserted upside down. Check This Out Top LavenderMist Posts: 361Joined: Fri Jul 13, 2007 5:09 amLocation: In the MistGender: Reply with quote by LavenderMist on Tue Mar 18, 2008 7:49 am I've added this to CPAP

If not, and it's an expensive machine, you may want to send it to the manufacturer for repairs. Respironics Bipap Autosv Error Codes The next obvious question is “What do I do next?”. You can see the Encore SmartCard in figure 4.

Please try the request again.

C-107 SMARTCARD_BAD_CPB_START_ADDR Card is corrupt and should be reprogrammed. I checked the clinician menu and didn't see anything there. Even if you do not have a humidifier, years of using a CPAP machine night after night, moving parts (blowers) will wear out regardless. Replace Main Pca Wilson at 12:52 PM 0 comments About Me Name: R.

TIA, minime Hi minime, welcome to the forum! C-5 SMARTCARD_PRESENT_IN_CAL_MODE Remove card. Or, you could purchase another one. http://exactcomputerrepair.com/error-codes/pos-error-codes.html couldn't see the part number.

C-10 SMARTCARD_BAD_RI_BRAND Card is corrupt and should be reprogrammed. Then reinsert card. The Puritan Bennett 420G CPAP machine only has four screws, but they're weird ones that appear to require some sort of star-shaped allen-wrench-type of tool for removal.